Troubleshooting - LGR 7000 XLi

<< Click to Display Table of Contents >>

Owner's Manual >

Troubleshooting - LGR 7000 XLi

Previous pageReturn to chapter overviewNext page

FAULT

CAUSE

SOLUTION

Water drips out when moving unit

Unit was unplugged before purging was complete.

Purge unit before moving. See At the End of the Job.

Unit does not operate

Unit not switched on.

No power to machine.

Switch unit on.

Plug in unit; check power cord connection at wall outlet.

Unit operating, but room not dry

Not enough time to dry.

Poor air movement in room.

Excessive moist air infiltration.

Make sure “Humidistat” is OFF. Allow more time for drying.

Increase air movement with air movers.

Seal off area to reduce infiltration.

Unit collects too little water

Room air is dry.

Room temperature is too low.

Filter is clogged.

Coils are clogged.

Make sure “Humidistat” is OFF.

Confirm humidity level with hygrometer.

Increase room temperature.

Check filter. Replace as necessary.

Check coils. Clean as necessary.

If the problem you are experiencing is not listed here, contact your Legend Brands location for further assistance.